ProfiLux 4 Resource Guide
EN 2018-13-11 44
D. The number of hours the probe has been used can be tracked here.
Probe/sensor controls – Level settings
The LEVEL settings page is where you can program how Level sensors will function. Level
sensors are GHL-branded Float switches, optical sensors, leak sensors, and flow sensors. These
sensors can be used for handling tasks such as ATO w/ 1 or 2 sensors, AWC, Leakage
detection, etc.
Level sensors are connected to one of the two
Level
ports on the back of the
ProfiLux 4 or to an expansion card that has a built-in
Level
port. Each port
supports up to two separate sensors. Two sensors can be used when you use
a GHL splitter cable,
PL-0081 PL-LY
.
A. This is the main area of focus. Here is where you can program specific level sensors for
various purposes. The name
Control Circuit
refers to the function number. When you’re
assigning a Level function to a specific Powerbar socket, you must recall what
Control
Circuit
number you used when you created the function and assign that number to the
Powerbar socket.
a. Double-clicking on a Control Circuit will bring up this window, see (a).
i. Operation mode: Used for programming the function of a level sensor.
To Next Page
Loading...
Need help?
General
