GMP PROTOPIC AUTO-540 HS - How to Use Main Devices: Feeder System; Feeder Fixing and Height Adjustment

How to use the Main Devices
⑥ - Feeder Fixing Knob
To fix a position of Feeder
Adjust its position for stacked sheets and fix it.
NOTE : If the Feeder would not be fixed, this could be a cause of damage on the feeder while lamination.
⑦ - Feeder Height Adjustment Knob
Adjust the Feeder height position.
If the feeding table would be moved upward as the below picture,
recommendable distance between sheets and alignment device is 3~5mm.
3~5mm
6
7
34/66