How to use the Main Devices
☞ How to adjust Perforator
To make holes at the edge lines of films for easy cutting of laminated results.
Place the perforator at 1~3mm from film edge.
Adjust its height to make holes on the films clearly.
WARNING : For initial loading or for moving of perforator, loosen the height adjustment knob.
Otherwise, this could be a cause of damage on perforator or on roller.
☞ Skewing Wheel
To make laminated results cut easily and clearly.
As the right picture, install the wheel to make sheet curve. This is to delay the laminated results exit to increase of cutting quality.
Wheel angle has to be adjusted to prevent laminated result fold.
WARNING : If Skewing Wheel would not be installed properly, the laminated results could be folded.
Perforator Height Adjustment Knob
To Next Page
Loading...
