Maintenance
※ If the roller would not be cleaned;
- Film could be stuck & wound on the roller.
- The laminated results could be contaminated.
※ How to Clean
- After lamination job is done, when the laminating roller temp. is lower than 80℃, clean the roller with "cotton" & "Isopropyl alcohol".
WARNING : Isopropyl alcohol is required to clean the rollers.
WARNING : Laminating Roller temp. is too high, then if a part of body would be contacted, this could be a cause of burn.
※ To clean the body of the machine
- Smooth and dried cloth is required to clean the body of the machine.
WARNING : Unplugged status is required. Otherwise, this could be a cause of fire.
WARNING : 아 Do not use a volatile such as, Acetone, Benzene, Thinner. This could be a cause of fire.
To Next Page
Loading...
