Cleanup
36 3A6748B
10. Run pump until cleaning balls exit
material hose. Hold material hose
securely while passing balls through it.
Pressure can build up and make hose
jump. Save cleaning balls.
11. Rotate Pressure Control Knob to shut
pump OFF.
12. Connect applicator to material hose.
13. Turn Pressure Control Knob clockwise
to start pump.
14. Run pump until clean water flows from
applicator. Continue until hopper is
empty.
15. Add additional water and repeat steps 13
- 14, if necessary.
NOTE: After flushing with water, flush again
with Pump Armor to leave a protective
coating to prevent freezing and corrosion.
To Next Page
Loading...
Need help?
General
