GRAPHTEC CE6000 SERIES - Page 113

CE6000-UM-251-9370 7-16
7 ELECTRICAL ADJUSTMENTS
(15) Load a sheet of A3 size paper into the plotter.
(16) Press the F3 key (DISTANCE ADJUST) to display the following menu.
(17) Press the Down arrow key (ADJUSTED PATTERN) to display the following menu.
(18) Press the F3 key (SHEET).
(19) The plotter detects the paper size, and then plots the adjsuted pattern.
Press the Left arrow key after input the adjustment value. The following menu is displayed.
(20) Remove the paper and measure the X- and Y-axis distances.
(21) Conrm the adjsuted pattern has 250 mm x 250 mm
Press the ENTER key at the following menu if measured distance is within 250 mm ±0.2 mm.
(22) The following menu is displayed.
(23) Turn off the power.