SK200-UM-251-9370 3-2
3. PREPARING TO OPERATE THE SCANNER
3.2 Turning the Power On and Off
The LED (blue) on the [POWER] button changes as follows to indicate the scanner’s power supply status.
• Unlit: The scanner is turned off.
• Lit: Lights when the scanner is turned on and remains lit while it is operating normally.
• Flashing: Flashes when the scanner is in power-saving mode.
Turning the Power On
Press the [POWER] button on the scanner’s control panel.
When the scanner is in the power-on status, the [POWER] button lights blue.
Turning the Power Off
Press the [POWER] button on the scanner’s control panel.
When the scanner is in the power-off status, the [POWER] button LED is extinguished.
After the scanner has been turned off, wait at least five seconds before turning it on again.
Notes on the power-saving mode
The scanner automatically switches to power-saving mode (the blue LED on the power button flashes) after
approximately 12 minutes have elapsed without a document being loaded in the scanner. To return the
scanner to normal status (Local status), press either the [STOP] or the [EJECT] key.
To cancel the
powe
r-saving mode
To Next Page
Loading...
