GRAPHTEC SK200-09 - List of Jigs and Tools; Jigs; Tools; Other

SK200-UM-251-9370 7-1
7. LIST OF JIGS AND TOOLS
7. LIST OF JIGS AND TOOLS
7.1 Jigs
Jigs Adjustments Remarks
SK200-09 firmware •Downloading system program Firmware (SK200SP.X)
Scanning Master 21+
(Ver. 6.40 or later)
•Downloading system program
•Shading (white correction)
•Adjusting feed distance
•Aligning sensor images
•Adjusting offset
•Color correction
Software supplied with the scanner
(Scanning Master 21+)
Calibration sheet •Shading (white correction) Standard accessory
1050 mm x 200 mm
Color correction sheet •Color correction Standard accessory
42-inch adjustment test chart •Adjusting feed distance
•Adjusting offset
•Aligning sensor images
Record measured values between a and
c, b and d, a and b, c and d, a and d, and
b and c.
Shim 0.2 mm
•Roller gap adjustment (Between feed
roller and contact glass plate)
Shim 0.3 mm
Mylar sheet #300 • Confirmation of the grip pressure Thickness 0.075 mm
7.2 Tools
Tools Usage Remarks
Screwdriver
Allen wrench (2 mm to 4 mm)
Needle-nose pliers
Disassembly, reassembly, and other
operations
Large, medium, and small flat blade
screwdrivers and Phillips screwdrivers
Push/Pull gauge 5 k
g Adjusting belt tension
Multimeter Checking voltage level
7.3 Other
Item Usage Remarks
Water-diluted neutral detergent or
absolute ethanol wiper (cloth)
Cleaning
PC
USB cable
Used to determine whether the problem
is caused by the scanner or other
equipment.