SK200-UM-251-9370 8-9
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.9 Adjusting Feed Drive Belt Tension (60S2M250)
Adjusting the feed drive belt tension
(1) Loosen the two M4L6 binding head screws holding the feed drive belt tension bracket.
(2) Loop the wire around the feed pulleys as shown in the photograph below.
2 kgf
M4L6 binding head screw
Feed drive belt tension pulley
Feed pulley
Wire
Push/pull gauge
(3) Use the push/pull gauge to pull the feed drive belt tension pulleys with a 2 kg force as shown above.
(4) Tighten the two M4L6 binding head screws that hold the feed drive belt tension bracket.
To Next Page
Loading...
