SK200-UM-251-9370 8-11
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.11 Adjusting the Motor Drive Belt Tension (60S2M284)
Adjusting the motor drive belt tension
(1) Loosen the two M4L8 pan head screws with washer holding the motor.
(2) Loop the wire around the motor pulley as shown in the photograph below.
3 kgf
M4L8 pan head screw with washer
Motor drive belt pulley
Wire
Push/pull gauge
Motor drive belt
(3) Use the push/pull gauge to pull the motor pulley with a 3 kg force as shown above.
(4) Tighten the two M4L8 pan head screws with washer that hold the motor.
To Next Page
Loading...
