GRAPHTEC SK200-09 - Right Side Cover

SK200-UM-251-9370 8-3
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.3 Right Side Cover
Detaching the right side cover
(1) Detach the top cover (see Section 8.1).
(2) Remove the two M4L8 TP screws on the right side of the scanner unit.
Note:
There is a positioning pillar inside the right side cover.
Do not twist the cover when removing the cover.
Otherwise, you will break the positioning pillar.
M4L8 TP screw
Right side cover
(2) Disconnect the control panel cable from the control panel board.
Right side cover
Positioning pillar
Control panel board
Control panel cable
(3) Detach the right side cover.
Reattaching the right side cover
(1) Reattach the right side cover in the reverse order in which it was detached.