SK200-UM-251-9370 8-30
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.21 CIS (Contact Imaging Sensor) Board
Detaching the CIS boards
(1) Detach the top cover and the shield cover (see Sections 8.1 and 8.6).
CIS board
(2) Disconnect all the connectors on the CIS board and remove the two M2L6 binding head screws holding
the CIS board.
M2L6 binding head screw
(3) Detach the CIS board from the unit.
Reattaching the CIS boards
(1) Reattach each CIS board in the reverse order in which it was detached.
(2) When you have replaced the CIS boards, perform calibration using the software adjustment.
How to find out type of the CIS boards
There are two kinds of the CIS boards, which is used to SK200-09 or SK200-09-A.
So prepare corresponded CIS boards before replacing the CIS boards.
The model name label is showing the type of the CIS boards.
If the model name is SK200-09 use the old type of the CIS boards.
If the model name is SK200-09-A use the new type of the CIS boards.
Confirm this label to find out the type of board.
To Next Page
Loading...
