SK200-UM-251-9370 8-10
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.10 Motor drive belt (60S2M284)
Detaching the motor drive belt
(1) Detach the top and left side covers (see Sections 8.1 and 8.2).
(2) Detach the feed drive belt (see Section 8.8).
(3) Loosen the two M4L8 pan head screws with washer holding the motor.
(4) Detach the motor drive belt from the pulleys.
M4L8 pan head screw with washer
Motor drive belt
Reattaching the motor drive belt
(1) Reattach the motor drive belt by reversing the sequence of steps in which it was detached.
(2) Adjust the belt tension (see Section 8.11).
To Next Page
Loading...
