SK200-UM-251-9370 8-14
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.13 CIS Sensor Unit Assemblies
Detaching a CIS sensor unit assembly
(1) Detach the top and shield covers (see Sections 8.1 and 8.6).
(2) Detach the board base chassis (see Section 8.12).
Spring stopper bracket L
Front left CIS sensor unit assembly
Spring stopper bracket
Rear CIS sensor unit assembly
Front right CIS sensor unit assembly
Front center CIS sensor unit assembly
When detaching the spring stopper brackets, mark the location of each spring stopper bracket. Do not swap the
location of each spring stopper when installing the spring stoppers.
(Especially when detaching the rear left CIS sensor unit assembly)
Center CIS sensor unit assembly
(3) Remove the four M3L6 binding head screws holding the spring stopper bracket L and the spring stopper
bracket.
M3L6 binding head screw
Spring stopper bracket L
Front center CIS sensor unit assembly
Spring stopper bracket
To Next Page
Loading...
