SK200-UM-251-9370 8-13
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
(5) Gently lift up the front of the board base chassis, and then pull out the CIS flexible cables under the
board base chassis.
Note:
There are CIS flexible cables connected to the CIS unit under the board base chassis.
Therefore, do not lift up the board base chassis forcibly.
(6) Lay the board base chassis down at the rear of the main unit as shown below.
Reattaching the board base chassis
(1) Reattach the board base chassis by reversing the sequence of steps in which it was detached.
To Next Page
Loading...
