SK200-UM-251-9370 8-16
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
Reattaching a CIS sensor unit assembly
(1) Reattach the CIS sensor unit assembly by reversing the sequence of steps in which it was detached.
(2) Use a CIS sensor of the same rank when replacing a CIS sensor.
The CIS sensor rank is indicated on the CIS sensor unit and the bottom of the scanner chassis.
(3) Perform the CIS sensor unit height adjustment (see Section 8.18) and the software adjustment.
How to find out the CIS sensor rank
There is the CIS sensor rank label on the bottom chassis as shown in a picture below. so prepare same rank
of the CIS sensor before replacing the CIS sensor.
To Next Page
Loading...
