SK200-UM-251-9370 8-28
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
Detaching the data controller board for the SK200-09-A (New))
(1) Detach the top cover and the shield cover (see Sections 8.1 and 8.6).
Data controller board
(2) Disconnect all the connectors on the sub-data controller board and remove the two M2L6 binding head
screws and M3L6 binding head screws holding the sub-data controller board.
M2L6 binding head screw
Sub-data controller board
M3L6 binding head screw
(3) Detach the sub-dara controller board from the data controller board.
(4) Disconnect all the connectors on the data controller board and remove the three M3L6 binding head
screws and the stud holding the sub-data controller board.
M3L6 binding head screw
Stud
Data controller board
(5) Detach the dara controller board from the unit.
To Next Page
Loading...
