GRAVOGRAPH M20 - Recommendations for Installation; Physical Installation

28
M_M20 series_EN_C
H. Recommendations for installation
Turn o󰓐 the machine before any intervention (put the On/O󰓐 switch in the "O" (O󰓐)
position).
1. Physicalinstallation
• Placethemachineonahorizontal,stableandcleansurfacethatcansupport100kg(220.462lb)ormore.
• Place the machine in a clean, ventilated environment.
• Ambientlightisenoughtolighttheequipmentproperly.
• Arrangetheworksurfaceforrapidandeasyaccesstoeachexternalpartofthemachineand,ifnecessary,
to the main machine stop button.
• Do not obstruct the movement of the moving parts of the machine.
Make sure the connector screws are properly tightened to prevent the cables from
becoming disconnected while the machine is switched on. This could cause permanent
damage to the circuit boards.
Thepowercablemustalwaysbeeasilyaccessible(powershut-o󰓐device).
• Protecttheequipmentagainst:
- damp (rain, snow, condensation etc.)
- heat (exposure to full sun, heating etc.)
- sudden changes in temperature
- dust (extraction duct)
- spillagesofliquidsontotheelectricalunit,cablesandconnections,andallotherpartsofthemachine;
exceptinsituationsrecommendedbyGravotech(lubrication)
- vibrations
- electrical/electronic radiation