GRAVOGRAPH M20 - Start-Up Engraving

52
M_M20 series_EN_C
Using the machine
7. Start-up engraving
Engraving is launched from the control panel on the machine.
1. Checkthattheobjectiscorrectlypositionedintheengravingarea.
2. Pressthekey:Start(controlpanel).
Thetoolholdermovesatasafemovementspeedtothe󰘰rstengravingpointandstartstheengraving.
Automatic ZRef: the spindle moves down until the diamond tip touches the plate. When the position of the
ZRef. has been stored, engraving starts.
Inordertoachieveafastermovementspeed,presstheStartkeyuntilthe󰘰rstengravingpointisreached.
• In the event of a problem, press the Pause button.
Themachinepausesmomentarily.
Toresumeengraving,presstheStartkey.
• Tostopengravingcompletely,pressoneofthearrowsonthejoystick.
• To accelerate the movement speed of the spindle during engraving, press the Up arrow.
• To slow down the movement speed of the spindle during engraving, press the Down arrow.