GRAVOGRAPH M20 - X84; Power down; X84; Restarting; X84; Program Installation

37
M_M20 series_EN_C
Connections - Installation
 Power down
1. Setthegeneralstopbuttontothe"O"(Stop)position.
M20ABC:alwaysswitcho󰓐theTouchPadbeforepoweringdownthemachine.
Switcho󰘯themachineinthefollowingsituations:
• whentheoperatorispermanentlyleavingthemachine
• in the event of physical damage (something is dropped on the machine, 󰘰re, a liquid is spilled on the
machine, etc.)
• mechanical/electrical/electronicfaultssuggestingabreakdown
• ifthereisamajorproblemorthemachineisjammedmechanically
• themachineisjammedontheparttobeengraved/marked
• themachineisjammedonanobjectintheworkarea
• forced restart
• external/internal cleaning
 Restarting
Ifthemachineortheoperatingprogramlocks,themachinemayneedtoberestarted.
1. Switcho󰓐themachine.
2. Wait approximately 30 s.
Thiswaitingtimemustberespected.Itpreventsanelectricsurgelikelytodamagethemachine'spowersupply.
3. Switch on the machine.
 Program installation
Refer to the user manual for the program.