GRAVOGRAPH M20 - Page 40

40
M_M20 series_EN_C
Using the machine
M20 JEWEL: to engrave a chain bracelet, place the chain bracelet protection on the vice.
1
2
1. Chain bracelet protection
2. Jewelryjigs
3. Ifthe"SetCorners"(PnSCorners)functionisnotused,markthemid-pointofthelengthofthe
objecttobeengraved.
4. Centertheobjecttobeengravedsuchthatthemarkontheobjectisalignedwiththe0notchon
thejig(centerorigin).
5. Usingthetighteningknob,clamptheobjectsoastoimmobilizeitduringengraving.
Correctclampinghelpstoreducethenoiseofthemachineandtominimizevibrationduringengraving.
Checkthattheobjectisclampedsuchthatitcannotbeejectedduringengraving.