7-22 Published 08-25-09, Control # 077-04
POWER TRAIN RT9130E SERVICE MANUAL
7. Connect the two radiator tubes to the radiator with hose
clamps and the radiator hose.
8. Secure the radiator return tube to the top of the engine
using nuts, washers and a muffler clamp.
9. Reinstall surge tank and connect the hoses between the
surge tank and engine and the surge tank and the
radiator.
10. Reconnect the charge air cooler tubes to the charge air
cooler using hose clamps and bellows.
11. Tighten the drain cock at the bottom of the radiator drain
hose.
12. Install the hood assembly.
13. Install the hardware holding the rear engine hood panel
to the engine hood.
14. Connect the hourmeter wiring.
15. Install the hood top door assembly.
16. Service the engine coolant system, as necessary. Refer
to Section 9 - Lubrication. Start the engine, operate all
systems and check for leaks.
Item Description
1 Surge Tank
2Baffle
3Clamp
4 Bellows
5 Overflow Hose
6Clamp
7 Muffler Clamp
8 CAC Tube - Hot
9 Bellows
10 Hose Clamp
11 CAC Tube - Cold
12 Hose
13 Clamp
14 Drain Cock
15 Bellows
16 Clamp
17 Fan Guard
18 Radiator
19 Radiator Hose
20 Flange Screw
21 Flatwasher
22 Radiator Hose
23 Shroud
24 Lower Radiator Hose
25 Plate
Item Description
To Next Page
Loading...
