User Manual
23
• To remove the battery, open the battery door, keep the battery depressed and then press
the pop-up button. Keep the pop-up button depressed, release the battery, then the
battery will bounce and you can pull it from the camera. When pulling the battery, please
still keep the pop-up button depressed
• Replace a fully charged battery as above instructed
Notes for the battery:
• Do slide the battery into the battery chamber until you hear a clear sound given by the
release button. Otherwise, the battery is not locked into place and the camera cannot work
well because of unstable power supply.
• When pulling the battery out of the camera, please ensure the pop-up button is depressed
till the battery finally offs the camera
• In the interim of replacing the battery, AC adapter can be connected to the camera without
powering off the camera. Then the AC adapter starts supplying power for the camera and
you can replace the battery with a fully charged one without powering off the camera. After
replacement, you can disconnect the AC adapter from the camera.
Battery Charging
Two methods are available to charge batteries:
• Charging in the camera
• Charging in an external battery charger
Charging in camera
• Properly insert the battery into the battery door and close the door; connect the camera to
AC adapter through the AC adapter cable, and then connect the AC adapter to a socket or
wall outlet
To Next Page
Loading...
