User Manual
5
• Do not jam the holes or loudspeaker on the camera body
• Do not re-switch on the camera until 15 seconds later after switching it off
• Do not throw, knock or vibrate intensely the camera and its components in order to
keep them from damage
• Do not attempt to open the camera body, as this action will void the warranty
• Keep the SD memory card for the exclusive use of the camera
The THERMOPRO
TM
TP8 IR Thermal Camera utilizes a Lithium Ion (Li-Ion) rechargeable
battery pack. The following safety precautions must be adhered to at all times to ensure the
safe use of this equipment
• Do not disassemble or attempt to open the battery under any circumstances
• Do not expose the battery to fire or high temperatures
• Do not short circuit the battery
• Do keep the battery off moisture or water
• Charging of the battery should only be carried out using the recommended or
supplied charging device
Maintenance
To ensure that the THERMOPRO
TM
TP8 IR Thermal Camera is kept in good working condition
and remains fully operational, the following guidelines should be adhered to at all times
Non-optical surfaces
The non-optical surfaces of the camera can be cleaned when required, with a soft cloth
dampened with water and a mild detergent
Optical surfaces
The optical surfaces of the camera lens should only be cleaned when visibly dirty. Care should
be taken to avoid touching the exposed lens surface, as skin acid left behind from fingerprints
can be damaging to coatings and lens substrates. Use only a proprietary lens cleaning tissue
To Next Page
Loading...
