8. Press the Exit key to exit from
the configuration menu.
1. Press the Shift key, the 2nd
(Menu) key, and the Left key
repeatedly until the SET LAN
configuration menu appears.
Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see
page 142.
2. Press the Down key and the
Right key repeatedly until the
DNS selection display appears.
Note: The DNS address can
only be edited if DHCP is off.
3. Press the Down key. The DNS
address selection appears.
The DNS address is divided in 4 groups;
D1:D2:D3:D4. The cursor will be flashing on D1
(indicated by ―X‖).
4. Use the Left/Right keys to
move the cursor to the D1 value
and select a digit.
www. .com
information@itm.com1.800.561.8187
To Next Page
Loading...
