GW Instek GDM-8351 - Page 102

GDM-8351 User Manual
102
[MAX]
(Optional
parameter)
For commands, this will set the
setting to the highest value. This
parameter can be used in place of any
numerical parameter where indicated.
For queries, it will return the highest
possible value allowed for the
particular setting.
Automatic
parameter range
selection
The GDM-8351 automatically sets the command
parameter to the next available value.
Example
conf:volt:dc 2
This will set the measurement
item to DC Voltage and the range
to 10V. There is no 2V range so
the DMM selects the next
available range, 10V.
Message
Terminator (EOL)
Remote
Command
Marks the end of a command
line. The following messages are
in accordance with IEEE488.2
standard.
LF, CR, CR+LF,
LF+CR
The most
common EOL
character is
CR+LF
Message
Separator
EOL or ;
(semicolon)
Command Separator