ARBITRARY WAVE GENERATOR
241
This box shows the editing
window in relation to the full
ARB waveform
Editing window
1. Select a waveform from the GEN1 Setup/GEN2
Setup menu:
Press GEN1 Setup or GEN2 Setup
for generator 1 or generator 2,
respectively.
Press Waveform from the bottom
menu.
Select Arbitrary from the side menu.
2. Press the Waveform Edit from the
bottom menu.
3. From the bottom menu select Edit
Existing.
This will allow you to edit the ARB
waveform that is currently loaded
in memory. If no waveform has
been loaded, a DC waveform is
shown.
To Next Page
Loading...
