Haulotte HTT13 - Page 89

A
B
C
D
E
F
G
H
I
89 4000670450 E 04.19 USA / GB
E - General Specifications
3632T - HTT13
Flat spots
Wheel lockup and tire
skidding
Avoid sudden stops when
possible and adjust brakes.
Wheels replacement must be made in the following
cases :
• Deformation or cracks on the rim.
• De-bonding between the interface of the steel and the
rubber.
• Uniform wear to the wearing line.
• Non-linear wearing of the tread profile (> 10%)
• 1 wheel stud is completely torn.
• 2 successive wheel studs are partially torn.
Tires and rims are critical components for the stability of the machine. For safety reasons :
• Use only HAULOTTE® spare parts according to the technical characteristics of the machine. Refer to the
spare parts catalog.
• Do not replace factory-installed tires with tires of different specifications or ply rating.
• Never replace a solid (rigid) (Solid Tyre) tire with a foam-filled or a pneumatic (air-filled) tire.
Wear pattern Cause Action