90 4000670450 E 04.19 USA / GB
E
- General Specifications
3632T - HTT13
Procedure of replacement :
• Loosen the wheel nuts on the wheel to be removed.
• Raise the machine using a jack or a hoist.
• Remove the wheel nuts.
• Remove the wheel.
• Install the new wheel.
• Check for correct wheel nut tightening sequence.
• Lower the machine to the ground.
• Tighten the wheel nuts to the recommended torque. Refer to maintenance and repair
manuals.
N.B.-:-I
F A WHEEL HAS BEEN REPLACED, WHILE OBSERVING THE AXLE TRACK PATTERN CHECK FOR
CORRECT
INSTALLATION.
To Next Page
Loading...
