Trimble FMX , GFX750, 2050
1. Use CAN bridge harness HT9436.
2. If connecting to a GFX750 or 2050 monitor & TM-200 module.
•
Tee Y918 & Y919 to P4 on the Trimble CAN adapter harness
• Y919 to P4 CAN
• Y918 to Trimble harness connected to P4 (if any)
•
Enable ISO VT on Port B
3. If connecting to a FMX monitor.
•
Connect Y943 to either Port A or B on monitor or R3
Port replicator on Trimble CAN harness
• Connect Y942 to Trimble harness connected to Port (if any).
•
Enable ISO VT on appropriate Port A or B
13
Installation
To Next Page
Loading...
