Auto Engage Height
Sets the “auto engage/disengage” position of the feederhouse. This feature is
only available on combines equipped with feederhouse position sensors.
•
Lower the feederhouse to the height you want the system to engage below.
•
Press “Start Auto Engage Cal”
•
Calibrated feederhouse sensor voltage is displayed
Wheel Center
Calibrates the “straight ahead” position of the wheel angle sensor
•
Drive straight forward with no crop deflecting the crop sensor
•
Select “Learn Wheels Straight”
•
Calibrated “straight” sensor voltage is displayed
27
Calibration
To Next Page
Loading...