Operation with Horizon
When operating Truesight 2 with Horizon header height control,
Truesight 2 will replace the Horizon bridge.
1. Go to Setup>>WiFi>>Mode.
•
If you are running Horizon header height control select “Bridge”
•
If you are not running Horizon header height control select “Base”
2. You must cycle the key after this choice for it to be enabled.
Requirements for Operation
Engage Truesight 2 Road Mode any time you’re not using the Truesight
system. Road Mode will lock the automatic steering enable features.
Five requirements must be met before the Truesight 2 system will engage:
1. Seat switch safety must have contact
•
Operator must be sitting in seat to engage system
2. Road mode must be disabled.
3. Speed must be within range
•
Speed must be between 0.8 and 10 mph to engage system
4. Steering wheel rotation must be recognized before engagement.
•
Every power cycle rotate steering wheel at least ½ turn to relearn encoders
5. Steering wheel must be stationary during engagement.
When operating Truesight with an EZ-Pilot motor, disconnect the IMD 600, 900,
TM200, etc. so that the CAN does not interfere. (Does not apply to Ez-Pilot Pro.)
34
Overview
To Next Page
Loading...
