Deadband Sytem dependent, 2-10 typ.)
The Deadband setting adjusts the maximum swing of the crop
sensor before Truesight 2 issues a steer command.
Decrease the Deadband if:
•
The system wanders in the row without even trying to turn the wheels.
Increase the Deadband if:
•
The system is steering excessively often even on relatively straight rows.
Disengage Value (Default = 8)
The Override Value setting allows the operator to adjust how much motion of the steering wheel is required
to disengage Truesight 2. Increasing the override value will make it harder to disengage the system.
•
If Truesight 2 disengages with only a slight nudge of the steering wheel, the
Override Value may be increased to prevent accidental disengagement.
Disable Alarms (Default = Off)
Turns off the Truesight Engaged/Disengaged popups.
Auto Engage (Default = Off)
The Auto Engage feature allows automatic activation/deactivation of Truesight when
the feederhouse is lowered/raised through the setpoint chosen in the Auto Engage
calibration. This allows “touchless” operation while turning on the end-rows.
•
Auto Engage must be manually turned ON after every combine key cycle
Auto Engage Delay (Default = 2.5 sec)
The Auto-Engage Delay adjusts the time delay between when the operator lowers the header and
Truesight engages when using the Auto-Engage feature. The delay period starts when the feederhouse
lowers below the setpoint chosen in the Auto-Engage calibration. The delay allows the operator
a few seconds to manually guide the machine to the beginning of the row at the headland.
31
Settings
To Next Page
Loading...