Troubleshooting by Symptom
Nearly every problem with the Truesight 2 may be resolved
by one of the following simple steps:
•
Make sure each sensor meets the basic requirements discussed above
•
Properly calibrate Truesight system
•
Enable Truesight
•
Properly set the Truesight performance settings
Symptom Problem Solution
System will not engage
Still in Road Mode Exit Road Mode
Seat switch not ON
Sit on seat or repair switch
Safety Enables not connected See Installation
Steering wheel not turned since last
key cycle
Rotate steering wheel
Setup & Calibration not completed Complete calibrations.
Not moving
1-12 mph Drive forward at at least 1 mph
Sensors out of range Check Diagnostics
System is engaged but does not steer Steering device not working or installed
incorrectly
Correct in accordance with the
installation section of this manual
Wheels do not steer while driving
but do work during steering test (Go
to>>Diag>>Tab Right>>Steering Test)
Adjust Range, Deadband, Gain and
other settings in accordance with
Settings section of this manual.
Steering System Failure (Steering
device does not work with intended
system. Example: EZ-Steer with
Trimble controller.)
Contact local dealer to fix steering
device.
Truesight Controller Failure (Steering
device works with intended system but
not with Truesight installed.)
Contact Headsight to repair or replace
controller.
Truesight is weaving in rows Blue wands on sensor are not spaced
2
inches wider than corn row width
Correct spacing of corn arms
Settings are not correct Go to Settings section of manual and
adjust
44
Diagnostics
To Next Page
Loading...
