February 2012 11 – 135
8 Confirm the setting. --> The iTNC 530 HSCI proposes PLC:\PLCMEM.A as path and
file name.
8 Confirm the file name. --> The states or contents of the PLC markers and words are
saved in PLC:\PLCMEM.A on the data medium.
8 Exit the PLC mode.
Writing back
to RAM
8 Call the PLC mode. --> See ”Calling the PLC mode” on page 11 – 115.
8 Switch to the next soft-key row.
8 Call the TABLE function.
8 Switch to the next soft-key row.
8 Press this soft key. --> The iTNC 530 HSCI proposes PLC:\PLCMEM.A as path and file
name.
Figure: Writing back non-volatile PLC markers and words
8 Confirm the file name. --> The saved states or contents of the PLC markers/words
are written back to the RAM.
8 Exit the PLC mode.
To Next Page
Loading...
