HEIDENHAIN iTNC 530 HSCI - Inverters and Motors; Interface Boards for the SIMODRIVE 611 D Drive System

28 – 514 HEIDENHAIN Service Manual iTNC 530 HSCI
28.17 Inverters and motors
Inverter systems are powered via PWM outputs of the control.
--> See ”X51 to X56: PWM-output” on page 28 – 469.
The motor encoders are connected to the speed encoder interface of the control.
--> See ”X15 to X20: 1 Vpp speed encoder” on page 28 – 465.
28.18 Interface boards for the SIMODRIVE 611D drive system
The HEIDENHAIN interface boards for the SIMODRIVE system receive PWM signals from the control
and convert them.
--> See ”X51 to X56: PWM-output” on page 28 – 469.
Note
For further information, refer to the Service Manual "Inverter Systems and Motors".
Note
For further information, refer to the Service Manual "Inverter Systems and Motors".