13 – 174 HEIDENHAIN Service Manual iTNC 530 HSCI
13.6 Settings in the program manager
The iTNC 530 HSCI offers several possibilities of setting the program manager.
You can change these settings as follows:
8 Select the Programming and Editing operating mode.
(The program manager should not be open).
8 Call the code number window..
8 Call the interface setups. Here you also find the setting for the program manager.
The following window appears:
8 Place the cursor in the line PGM MGT.
8 Press the GOTO key. --> A selection window opens.
8 Select a setting and confirm with the ENT key.
8 Leave the settings page with the END soft key or the END key.
PGM MGT setting Advantages, e.g.
Enhanced 2 Complete mouse function, adjustable window sizes
Enhanced 1 Frequently used setting
Standard Display as with old HEIDENHAIN controls
For the descriptions in this iTNC 530 HSCI Service Manual the program manager was set to
Enhanced 1.
To Next Page
Loading...
