HEIDENHAIN iTNC 530 HSCI - Corrective Action

21 – 348 HEIDENHAIN Service Manual iTNC 530 HSCI
21.1.11 Corrective action
Mechanics If you have found that the fault is due to the mechanics of the machine tool:
 Replace mechanical components. --> Ask your machine tool builder.
Drive
components
If you have found that the power module, the compact inverter, the expansion card or the motor
is defective:
 Replace the drive component. --> See "Service Manual for Inverter Systems and Motors".
Control
components
If you have found that the interface on the CC 61xx is defective:
 Replace the CC 61xx. --> See ”Exchanging the CC” on page 29 – 550.
If you have found that the UEC 11x controller unit is defective:
 Replace the UEC 11x. --> See ”Exchanging the UEC” on page 29 – 551.