7 – 76 HEIDENHAIN Service Manual iTNC 530 HSCI
7.2 Automatic generation of service files
Service files are created automatically ...
in the event of serious NC error messages requiring a reset of the control.
if the NC software crashes due to a fatal error.
in the event of PLC error messages for which the machine manufacturer has defined that service
files are to be generated.
Figure: A service file is created automatically in the event of a serious error
7.3 Manual generation of service files
Service files can be created manually at any time:
8 Press the ERR key.
8 Press the soft key SAVE SERVICE FILES.
Figure: The Service file is generated manually
To Next Page
Loading...
