February 2012 16 – 221
16.3 Procedure
Extracting
the ZIP file
The provided ZIP file (e.g., 60642001sp2.zip) needs to be extracted to a data medium (USB flash drive
recommended).
A folder with the number of the NC software (e.g., 60642001) is created in which there is a subdirectory
(e.g., 606420_001_SP2) containing the following files:
setup.elf
setup.ini (optional)
setup.zip
Access to service
pack files via the
customer's network
If the control is integrated in the company network and the service pack files were filed on a shared
network folder, you have access to these data. --> If necessary, ask the system administrator.
Otherwise, you can also use a USB flash drive as data medium (or transfer the service pack from your
laptop to the control).
Loading the
service pack
8 Connect the USB flash drive to the control or to the monitor.
8 Select the Programming and Editing operating mode.
8 If open: Close the program management by pressing the END button.
8 Press the MOD key.
8 Enter the code word SETUP and press ENT to confirm. --> A pop-up window is displayed.
8 In the upper part of the window, place the cursor on the USB data medium (or on the partition of
the control's hard disk where you have transferred the service pack with TNCremoNT).
8 Now set the cursor to the folder with the designation of the NC software + service pack
(e.g., 606420_001_SP2).
8 Press ENT. --> The file setup.elf is shown in the lower part of the window.
iTNC 530 HSCI identifies standard USB flash drives.
HEIDENHAIN cannot guarantee that all USB flash drives available on the market work with the
iTNC 530 HSCI.
If the USB device is not detected, you can use TNCremoNT to transfer the service pack to the data
medium of the control.
Pressing the MOD key while the program manager is open calls screen where you can make the
interface settings.
With the +/- key you can open and close the directory trees.
To Next Page
Loading...
