30 – 568 HEIDENHAIN Service Manual iTNC 530 HSCI
30.5 IK 215 adjusting and testing package
The IK 215 is a hardware platform for the HEIDENHAIN ATS Software (Adjusting and Testing
Software).
The above package currently has the ID 547858-01.
The IK 215 is an adapter card for PCs (PCI bus) for inspecting and testing absolute HEIDENHAIN
encoders with EnDat or SSI interface.
The incremental signals of linear and angle encoders are also displayed.
With the SA 100 service adapter, the IK 215 can be connected in series between encoder and
control. Inspections at "operating speed" are possible.
Parameters (e.g. datum shift), the electronic ID label and OEM information can be read and written
via the EnDat interface.
The IK 215 Adjusting and Testing Package is delivered with detailed operating instructions.
These instructions are also available on the Internet in German and English. They can be
downloaded from www.heidenhain.de/...
A detailed explanation of the IK 215 Adjusting and Testing Package is part of our training
courses on measuring systems.
We recommend that you participate in a HEIDENHAIN service training course so that you can use
the IK 215 Adjusting and Testing Package correctly and efficiently.
Contact HEIDENHAIN Traunreut or your regional agency.
To Next Page
Loading...
