13 – 170 HEIDENHAIN Service Manual iTNC 530 HSCI
Data medium test
using soft keys
8 Press the EMERGENCY STOP button.
8 Restart the control.
8 Switch to the Programming and Editing operating mode.
8 Press the MOD key.
8 Press the DIAGNOSIS soft key.
8 Press the CHECK THE FILE SYSTEM soft key. --> A new window opens:
8 Press the YES soft key.
8 Then the file systems of the SYS partition (hda5/sda5), the PLC partition (hda6/sda6) and the
TNC partition (hda7/sda7) are checked and automatically repaired, if necessary.
This test can be called if the NC software still starts up completely.
The NC software is terminated and an EMERGENCY STOP triggered, before the file system will
be checked.
To Next Page
Loading...
