February 2012 14 – 193
TNCremoNT 8 Start the HEIDENHAIN data transfer program TNCremoNT.
8 Click this icon to open the configuration window.
(Can also be called via Extras / Configuration ... .)
8 Click on Connection and select serial connection (LSV-2).
8 Then click on Settings and select the serial interface (e.g. COM1).
8 Activate automatic detection of the data transfer rate on connection setup. --> The baud rate you
have set on iTNC 530 HSCI is activated.
8 Check the data transfer mode (BINARY-to-ASCII conversion). It should be set as follows:
8 Confirm with Apply and OK.
8 Click this icon. --> The connection is set up.
8 The TNCremoNT screen is split and the data medium of the control shown in the lower half of
the screen.
If you use a USB/RS -232-C adapter, automatic detection of the baud rate should not be active.
In this event set the transfer rate at the control and at the laptop to the same value.
If this does not work, check the connecting cable and the settings.
To Next Page
Loading...
