February 2012 14 – 201
Reading in data
using TNCremoNT
In the lower half of the screen (iTNC 530 HSCI contents), select the target drive and the target
directory:
8 Click the bar with the drive information. --> Its color changes, and two buttons appear at the right
side in the bar.
8 Click the Change folder/drive... button. --> A new window opens.
8 Select the drive and the folder. --> The path is displayed in the bar.
In the upper screen half (laptop/PC contents), select the source drive and the source directory:
8 Click the bar with the drive information. --> Its color changes, and two buttons appear at the right
side in the bar.
8 Click the Change folder/drive... button. --> A new window opens.
8 Select the drive and the folder. --> The path is displayed in the bar.
Transfer the data:
8 Using the mouse, click the directory you wish to read in.
8 Press and hold the left mouse button and pull the directory or the file into the lower window.
8 Release the mouse button. --> The directory or the file is being transferred.
For changing to the PLC: und SYS: control partitions, you are prompted the respective code
numbers.
When data is transferred with TNCremoNT, the data format is automatically converted from ASCII
(laptop/PC) to BINARY (control).
To Next Page
Loading...
