HEIDENHAIN iTNC 530 HSCI - Page 343

21 – 344 HEIDENHAIN Service Manual iTNC 530 HSCI
Block diagram
for two 1-axis
power modules
Block diagram
for a 2-axis
power module
DANGER
If motor brakes are connected to the power modules or output stages, they must be swapped
as well (X344, X392, X393, X394, depending on the model. --> See Service Manual for Inverter
Systems and Motors)!
Background:
Motor brakes can be connected to current HEIDENHAIN power modules (inverter modules)
and compact inverters. The motor brake is also powered with 24 V via a connector on the inverter.
The trigger signals for the motor brakes are transmitted via the PWM bus.
DANGER
If motor brakes are connected to the power modules or output stages, they must be swapped
as well (X344, X392, X393, X394, depending on the model. --> See Service Manual for Inverter
Systems and Motors)!
Background:
Motor brakes can be connected to current HEIDENHAIN power modules (inverter modules)
and compact inverters. The motor brake is also powered with 24 V via a connector on the inverter.
The trigger signals for the motor brakes are transmitted via the PWM bus.