February 2012 26 – 429
Functional test by
means of DriveDiag
8 Switch on the machine.
8 Turn the feed-rate potentiometer to a small value.
8 Call DriveDiag. --> See ”DriveDiag” on page 9 – 91.
8 Open the following page:
8 Start a probing cycle with the TT.
8 Check the lamp at TT touch probe ready (X13).
When the touch probe is ready, the lamp shines green.
8 Deflect the tool touch probe by hand.
8 Check the lamp at trigger signal of TT touch probe (X13).
When the touch probe is deflected, the lamp shines green.
The message Stylus deflected appears in the machine display.
Ask the machine manufacturer and observe the machine manufacturers's safety precautions
(set-up mode, etc.)!
To Next Page
Loading...
