February 2012 27 â 441
SPI expansion
module
Expansion module for analog axes/spindles in the HSCI system
CMA-H 04-04-00 (CMA-H = controller module analog HSCI)
Expansion module for analog axes/spindles in the
HSCI system:
î CMA-H 04-04-00:
Module for controlling analog axes or spindles.
The CMA-H is inserted in one of the SPI slots on the
bottom of the controller units. The analog control loop
outputs are accessed only via the NC. Interpolated
movements of analog axes with other axes are not
possible.
To Next Page
Loading...
