February 2012 28 – 455
28.2.2 Pin layouts
X3:
Connection for
screen soft keys
Screen soft keys from X3 to TE via ribbon cable
X26, X116:
Ethernet
interface
A hub serves as a central node that establishes the connection to the other participants.
Screen soft keys
BF 250 visual display unit TE 6xx keyboard unit
X3
D-sub connector, 15-pin
X1
Plug connector, 10-pin
X57
Plug connector, 50-pin
11a1b
22a2b
33a3b
44a4b
55a5b
9 1b 16a
10 2b 15a
11 3b 14a
12 4b 13a
Connection Maximum cable
length
Maximum data transfer rate Network
topology
RJ45, 8-pin Unshielded: 100 m For integration into the company network
via NFS or SMB protocol:
10 or 100 Mbps
Star configuration
Shielded: 400 m For LSV2 protocol (in conjunction with
e.g. TNCremoNT):
2 to 5 Mbps (depending on file type and
network utilization)
RJ45 connection (female) 8-pin Assignment
1TX+
2TX–
3REC+
4 Do not assign
5 Do not assign
6REC–
7 Do not assign
8 Do not assign
Housing External shield
The Ethernet interfaces of the MC 6xxx comply with the requirements of PELV ("low voltage
electrical separation") according to EN 61800-5-1 and are powered internally by 24 V NC.
All devices connected to these Ethernet interfaces must comply with the requirements of SELV
or PELV according to EN 61800-5-1.
To Next Page
Loading...
