29 – 520 HEIDENHAIN Service Manual iTNC 530 HSCI
The file MPNAME.MP is generated by the HEIDENHAIN operating system.
Axes cannot be traversed, spindles not switched on, and the control is set to Programming Station.
The HEIDENHAIN standard display colors are used.
There are no comments in MPNAME.MP.
Each parameter of the MPNAME.MP could now be set by the machine manufacturer.
In this case, the service engineer will restore the backup of the machine data.
--> See ”Restoring data” on page 14 – 207.
ESD protection ESD = Electrostatic discharge
To ensure protection from ESD, follow the precautionary measures described in IEC 61340-5-1,
IEC 61340-5-2 and IEC 61340-4-1!
The following are some points covered in the above mentioned standards:
8 When handling electrostatically endangered components or assemblies (e.g. exchange, installation,
shipping), always comply with the precautionary measures in these standards.
8 Store and transport ESD-sensitive components in ESD protective containers.
8 Ensure during handling the proper grounding of the working area (e.g. tool, workbench,
packaging) and the person.
8 Inspect the ESD protection system regularly.
When you exchange HEIDENHAIN components, you might come into direct or indirect contact
with electronic components.
Always assume that all electronic components and assemblies are endangered by
electrostatic discharge (ESD) and may be damaged by incorrect handling.
These ESD-sensitive components could also come into contact with a statically charged object
(tool, workbench, packaging, etc.)
Therefore observe the ESD protective measures, when you exchange MC, CC, HDR, buffer
battery and all devices with accessible electronic components!
Keep in mind that you can damage components that are not accessible simply by touching the pins
in connectors.
To Next Page
Loading...
