29 – 522 HEIDENHAIN Service Manual iTNC 530 HSCI
Information
about errors
If possible, write the assumed error or circumstances that caused the failure of the unit on a slip of
paper and apply it to the outside of the unit.
ID number for
service order
When placing a service order, always indicate the ID number of the HEIDENHAIN device concerned.
Serial number for
traceability
For reasons of traceability also indicate the serial number of the HEIDENHAIN device. The serial
number as well as the ID number can be found on the ID label of the device.
Replacement units
and spare parts
For replacement units and spare parts, ask your machine manufacturer!
This also applies for the NC software!
Please observe:
Always use original HEIDENHAIN components as replacements!
HDR and SSDR are normally equipped with the most recent NC software.
If you wish to keep the previously installed - older - NC software version, contact your OEM.
He can restore this version.
Please send the defective unit in its original packaging to your machine manufacturer or your
HEIDENHAIN agency.
Repair Many HEIDENHAIN units are not repaired on site but are exchanged or replaced. These devices are
exclusively repaired by the specialists of the HEIDENHAIN workshops. The devices are also updated
to the latest state-of-the-art and subjected to tests.
Packaging If possible, use the original packaging from HEIDENHAIN.
Inspection after
replacement
of electrical
components
According to DIN VDE 0113 part 1 / EN 60204-1, the following inspections are required after an
electrical component has been exchanged:
8 Check whether the electrical equipment corresponds to the technical documentation.
8 Check whether the protective ground system is continuous.
8 Perform a functional check.
Replacement controls are delivered with a form which you can use to provide information on the
error of the defective control.
If you purchase the NC software directly from HEIDENHAIN and require an older NC software
version, this software can be ordered in writing. Only then can/may HEIDENHAIN provide an older
- no longer up-to-date - NC software version!
To Next Page
Loading...
